Saving Energy
Saving energy is important and helps you save money. This section gives you tips on the best ways to save energy with your dishwasher.
Loading tips
l
l
Wash full loads. Running a
Load correctly for best washing results. Incorrect loading may cause poor washing. You will then need to rewash all or part of a load.
l Do not prerinse normally soiled dishes. Select the correct cycle for the load and use the recommended amount of detergent.
Cycle and option tips
l Use the Low Energy/China cycle whenever possible. The cycle uses less hot water and energy than the Normal Cycle.
lUse 4 Hour Delay Start to run your dish- washer during
l Do not use the High Temp Wash option if it is not needed. When this option is off, if water entering the dishwasher is lower than 140°F (6073, the cycle does not take additional time to heat water during the main wash.
NOTE: Loads may not wash or dry as well if the water temperature is too low. For best dishwashing results, water must be at least 120°F (49°C) as it enters the dishwasher.
l Use the Air Dry option whenever possible. Allow longer drying times (overnight). Use a rinse agent to improve drying.
To check water temperature:
1.Run hot water at the faucet closest to your dishwasher. Let the water run for at least 1 minute.
2.Hold a candy or meat thermometer in
the running stream of water. It water temperature at the faucet is below 120°F (49”C), have a qualified person raise the water heater’s thermostat setting.
23
