Operating Instructions
Continued
The PAUSE HEAT indicator
The “PAUSE HEAT” indicator and current water temperature will show on the display if the dish- washer needs additional time to heat water in the main wash. The water heating will continue until either the water reaches a temperature between 135°F and 140°F (57°C and 60%) or a preset
The CLEAN indicator
“CLEAN” will show on the display at the end of all cycles except for the Rinse Cycle. If the cycle included the Heat Dry Option, “CLEAN 8 DRY” will show at the end of the cycle. The indicator(s) will stay on until any control pad is pressed.
As an option, you can have the “CLEAN” (or “CLEAN & DRY”) indicator turn off the first time you open the door after a cycle is finished:
1. Press and hold the OPTIONS pad until “CLEAN” shows on the display and starts blinking.
2. Release the OPTIONS pad. The “CLEAN” indicator will turn off.
NOTE: A power failure will reset this feature. You will have to repeat the above steps.
To again have “CLEAN” (or “CLEAN & DRY”) stay on when the door is opened:
1. Press and hold the OPTIONS pad until “CLEAN” shows on the display.
2. Release the pad. The “CLEAN” indicator will turn off.
Other status indicators
“WASHING” shows on the display during the wash portion of the cycle. The indicator goes off when the last wash of a cycle is complete.
“RINSING” shows on the display during the rinse portion of the cycle.