4.Install foam seal in the gap between air conditioner base and cabinet. Push foam seal in at the sides and trim any excess material.
A
A. Foam seal
5.Remove the 2 front panel screws from air conditioner base.
6.Insert front tabs of front panel into top of cabinet and swing front into place.
7.Attach bottom front of panel with front panel screws. Replace control knobs (on some models).
NOTE: Route power supply cord through notch in front panel.
B
A
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
8.Plug into a grounded 3 prong outlet.
9.Press RESET on the power supply cord plug.
A. Front panel screws
B. Power supply cord notch
AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■If you turn off the air conditioner, wait at least 3 minutes before turning it back on. This prevents the air conditioner from blowing a fuse or tripping a circuit breaker.
■Do not try to operate your air conditioner in the cooling mode when outside temperature is below 65°F (18°C). The inside evaporator coil will freeze up, and the air conditioner will not operate properly.
NOTE: In the event of a power failure, your air conditioner will operate at the previous settings when the power is restored.
Starting Your Air Conditioner
1.Remove clear protective film from front panel badge (on some models).
2.Set the Exhaust control. See “Exhaust Control (on some models)” later in this section.
3.Set the Fan Control to desired setting. See “Fan Control” for your particular model later in this section.
4.Turn the Thermostat control to a
“Thermostat” for your particular model later in this section.
9
