Whirlpool ACG052XJ0 manual EN Operating Your Air Conditioner, Starting your air conditioner

SET TEMP./

TIME

–

+

EN Operating Your Air Conditioner

Operating your air conditioner properly helps you to obtain the best possible results.

This section explains proper air conditioner operation.

IMPORTANT:

•If you turn the air conditioner off, wait at least 3 minutes before turning it back on. This prevents the air conditioner from blowing a fuse or tripping a circuit breaker.

•Do not try to operate your air conditioner in the cooling mode when outside temperature is below 65°F (18°C). The inside evaporator coil will freeze up and the air conditioner will not operate properly.

Starting your air conditioner

TIMER

ON OFF

TIME TIME

CLOCK

+

–

		SET TEMP./
AM	PM	TIME

AUTO COOL

COOL

FAN ONLY

MODE

TURBO

HIGH

LOW

FAN SPEED

SLEEP

CHECK

FILTER FILTER

RESET

OFF

Press any control key to turn on the air conditioner.

TIMER
1. Press TIMER key to set the ON	TIMER
TIME. The indicator light and
“--:--” will flash. Press the “+” or	ON OFF
“–” key to set the ON TIME.	TIME TIME

2.Select MODE, FAN SPEED or SLEEP. If an OFF Time is desired, go to step 3. If not, press the TIMER key twice to accept the setting. The ON TIME indicator light will stay on.

3.Press TIMER key a second to set the OFF TIME. The ON TIME indicator light will stay on and the OFF TIME indicator light and “--:--” will flash. Press the “+” or “–” key to set the OFF TIME.

4.Press TIMER key a third time to accept settings. The indicator light or lights stay on until each setting is reached.

To cancel ON TIME and/or OFF TIME, press and hold TIMER key for 3 seconds.

To review settings, press once to view ON TIME, press a second time to view OFF TIME, and press a third time to exit.

CLOCK

1. If air conditioner is in the FAN ONLY mode or OFF:

•Press the CLOCK key to set the time. You will see the colon flashing.

If air conditioner is in the AUTO COOL or COOL mode:

•Press the CLOCK key one time to display the time of day.

•Press the CLOCK key again to set the time. You will see the colon flashing.

+

–

			SET TEMP./
CLOCK	AM	PM	TIME

2.Press the “+” or “–” key to set the correct time. After setting the time, press the CLOCK key again to start the clock.

Optional: To display the clock in the 24-hour format, press and hold CLOCK key for 3 seconds.

TEMPERATURE SELECTION

Press the “+” key to raise the temperature. Each time you press or hold the “+” key, the temperature will go up 1° until it reaches 86°F. Press the “–” key to lower the temperature. Each time you press or hold the “–” key, the temperature will go down 1° until it reaches 64°F. In the OFF mode, to view current preset temperature selection, press the “+” or “–” key.

Note: To change from “°F” to “°C” or from “°C” to “°F”, press and hold the MODE key for 3 seconds.

MODE SELECTION
Press the MODE key until you see	AUTO COOL
the indicator light come on for the	COOL
setting you want. Choose AUTO
COOL, COOL, or FAN ONLY.	FAN ONLY

AUTO COOL - Cools room to a

preset temperature while itMODE automatically controls the fan

speeds. You can change the preset temperature to one of your choice. COOL - Cools the room to your preset temperature. You can adjust the fan speed to LOW, HIGH or TURBO.

FAN ONLY - Fan runs continuously to circulate the air. No cooling takes place. You can adjust the fan speed to LOW, HIGH or TURBO.

5