Whirlpool ACS088PR0 Install support platform, Install air conditioner in window, A B C D, A B D

Install support platform Install air conditioner in window

1.Slide open one window sash to install support platform.

2.Loosely attach support angle to bottom of support platform using two ⁷⁄₁₆" machine screws, flat washers and nuts.

A

B

C

D

	E
	F
A. ⁷⁄₁₆" machine screws	D. Nut
B. Support plate	E. Support angle
C. Flat washer	F. Leveling bolt and locknut

3.Place support platform against lower window track and firmly against vertical edge of window frame.

4.Attach support platform to windowsill using two 1" wood screws.

If required, overcome interference of support platform with window track or storm windows by securely attaching a shim strip to the windowsill. Shim strip should be as long as width of support platform and flush with back edge of sill. Thickness of shim strip should be controlled by amount of interference.

A

B

D

		E
C
	A. 1" wood screws	D. Windowsill
	B. Support plate	E. Shim strip
	C. Lower window track

5.Pull support angle against outside of structure. Tighten two ⁷⁄₁₆" machine screws on top of support platform.

6.Adjust leveling bolt to level support angle. Tighten leveling bolt locknut.

NOTE: Air conditioner must be level or tilted back slightly to facilitate proper condensate disposal.

7.Cut two pieces of seal to height of window opening. Remove backing and apply to window frame and sliding sash that will rest against air conditioner cabinet.

1.Slide air conditioner onto support platform. Check to be sure air conditioner side channel fits securely against vertical edge of window frame.

NOTE: If air conditioner side channel does not fit securely against window frame, remove air conditioner and readjust leveling bolt.

2.Drill two ¹⁄₈" holes through the window channel frame in alignment with existing holes in bottom bracket. Install two ³⁄₈" self-tapping screws through these holes.

NOTE: If window channel frame is not tall enough to use existing holes, drill two new holes off to the side of the existing holes to attach the air conditioner bottom bracket to the support platform. Air conditioner should be firmly anchored to window channel frame or support platform.

A

B

C

D

A. Window channel frame	C. Bottom bracket
B. ³⁄₈" self-tapping screw	D. ¹⁄₈" drilled hole

3.Slide inside window sash closed. Check to be sure vertical edge of inside window sash is pressed firmly against side of air conditioner cabinet. Cut remaining seal to width of window opening. Remove backing and apply to top inside edge of window frame.

4.Install speed clips on top and bottom inside edge of window to provide locking.

5.Using supplied plastic seal, cut to proper length, insert between inside window sash and outside window.

A

B

C

A.Speed clip

B.Window channel

C.Plastic seal

6.See “Complete Installation.”

6