Instdlsth | InstmcUoms |
|
Contlnwd |
|
|
|
| 4. Attach support bracket (Item 2) loosely to |
Room side |
| the underside of shelf with either short or long leg |
| down and with end of bracket either toward or | |
|
| |
|
| away from window, depending upon con&uction |
|
| and depth of wall and window sill (see diagram). |
|
| Attach sill bracket (Item 3). Each bracket is |
t |
| attached using one %s” bolt, nut and washers |
| (Items 4,4A, 48 and 4C). | |
|
| |
|
| 5. With the assembled shelf and brackets still |
| in the window opening, adjust brackets until she8 | |
|
| is firmly seated and sloping down to outsiie. If you |
|
| use a level, be sure you have ?I2bubble of slope. |
|
| Wtiout a level, place the translucent panel (Item |
|
| 5) on shelf. The top of long side of the panel will be |
|
| %s” back from the window line (see diagram). |
5. If slope back is correct, tighten all nuts
Uw screws 5 or 5Asecurely. Install lower track seal (Item 9) shown in diagram. This track seal has two holes which line
up with matching screw holes in shelf.
Prodrill ‘Hu”holes
if truks are metal
7. install shelf 2%” from side of window open- ing, securing it in place with screws 6 or 8A.
8. Measure height of opening (see diagram). Subtract 20%~” from measured height. This will be the actual height of translucent panel.
9. Measure out the distance determined in Step 8 and mark it along the 20%” side of translu- cent panel. Clamp panel between a board and an appropriate supporting surface close to the mark and cut with fine tooth saw. Remove burrs.
10. Lift vertically removing panel frame from unit. Slide translucent panel into groove in frame, keeping honeycomb side to the face side of frame (see diagram). Slide frame back into place on unit. Panel should enter the top angle groove.
8