Installation Instructions
Continued
Installing in a new sleeve
1. Remove the front and back covers. Save these for future use to seal the sleeve if the air conditioner is removed.
2. Remove the rear grille from the sleeve.
3. Brush out all debris from inside the sleeve making sure the inside is clean and that the drain holes are completely clear.
4. Loosen screws in the rear grille to about W Then, while holding on to the wire loop, tip the grille and pass it through the rear opening of the sleeve. The baffle contact area should be on the left.
5. Align the grille to engage the screw heads through the keyhole slots in the outer flanges of the sleeve. Push downward until the screws are positioned into the bottom of the keyhole slots. Tighten all 4 screws, and unwind and discard the wire loop.
6. Unpack the air conditioner according to the carton instructions.
