1.To remove outer cabinet:
a.Disconnect power cord.
b.Take off the front plastic grille. Remove the two screws at the bottom. Drop grille down and take out.
TOP FLANGE
SOCKET HEAD
SCREWS / (slde of cabinet)
II I
c. Remove the cabinet screws on each side and top flange screws (see illustration). On 30, 40 and 48 pt. models, also remove rear grille. Pull out at bottom and drop grille down.
d. Lift cabinet from unit,
2. Coils should be inspected annually Brush clean, if necessary, with warm water and mild de-
tergent. Rinse and dry. Be sure power supply
.
5.The compressor is sealed and needs no oiling. However, the fan motor should be checked an-
r c6c
/:
m mllv nnrl nilcrd
OIL FAN MOTOR
(maCK VII Hole
Not Shown)
4.To oil fan motor, place a few drops of a good grade oil in both oil holes located on the fan motor. Oil capsules can be ordered [Part No. 10943) from your dealer.
5.Wash plastic parts with a soft cloth, warm water and mild detergent. Rinse and dry with a soft cloth.
6.Replace cabinet grille(s). Reconnect power supply cord.
8
