Whirlpool DP4800XS Connecting your portable dishwasher, Before starting, When cycle is finished

Connecting your portable dishwasher

A special adapter must be installed on the faucet before the dishwasher can

be connected. Complete instructions and the adapter are packed with your dishwasher.

When moving your dishwasher, make sure the door is latched. Use the built-in pull bar or hold it at the top front corners.

3.Lift slightly on the hose connector while pull- ing down the locking collar. Pull down on the connector.

4.Empty any remaining water from the connector.

5.Unplug power supply cord and return to storage compartment.

6.Return hoses to storage compartment.

Before starting

1. Run water at faucet until it is hot. Turn it off

PULL RING

2.Pull hoses out of therr storage compartment on the back.

ING COLLAR

/L HOSE CONNECTOR

3.Pull down on the locking collar while lifting the hose connector onto the faucet adapter.

4.When the connector snaps into place, re- lease the locking collar.

5.Turn the hot water on slowly until it is all the way on.

6.Plug in power supply cord.

7.See pages 8 and 9 to start the dishwasher.

While dishwasher is running

You can draw water from the faucet while the

dishwasher is connected. DO NOT draw water while the dishwasher is filling or while water is being pumped out. (This helps prevent a low fill when dishwasher is filling, or mixing drain water with fresh water.]

1.Press red button on hose connector to get the water you want. [The faucet is set on hot. Adjust faucet for the water you want.)

2.Be sure You return cold water to off, and that hot water is full on.

When cycle is finished

1.Turn hot water off. (This can be done after the last rinse.)

2.Press the red button on the connector to re-

t4 lease the water pressure.

Electrical Connection

A power supply of 120 volts.60 Hz or 110volts, 50 Hz, AC only, 15 amps, is required. For your personal

safety, this appliance must be grounded. This ap- pliance is equipped with a power supply cord having a J-prong grounding plug. To minimize possible shock hazard it must be plugged into a mating J-prong grounding type wall receptacle,

grounded in accordance with the National Elec- trical Code and local codes and ordinances. If a

mating wall receptacle is not available, it is the personal responsibility and obligation of the cus- tomer to have a properly grounded 3-prong wall

receptacle installed by a qualified electrician. DO NOT use an extension cord.

1

Power Supply Cord

DO NOT, UNDER ANY CIRCUMSTANCES, RE- MOVE THE POWER SUPPLY CORD GROUND PRONG.

Converting to built-in

Your Whirlpool Portable Dishwasher can be

converted to a built-in (undercounter) model by using conversion kit No. 569056. The kit is

available at your Whirlpool dealer or autho-

rrzed TECH-CARE” Service Company. Instruc- tions are included with the kit.

Caring for

simulated wood top

The simulated wood top can be used as a utility work surface for most kitchen jobs. It is stronger and more easily cleaned than genu- ine wood.

The top can be used as a cutting board. Knife marks will be visible but will not seriously dam- age top. Hot items from the oven can be placed on the top.

Clean with warm, soapy water. For dried on foods, use a scouring pad