12 place setting
■Place items so open ends face down for cleaning and draining.
■Load glasses in top rack only. The bottom rack is not designed for glasses. Damage can occur.
■Place cups and glasses in the rows between tines. Placing them over the tines can lead to breakage and water spots.
■China, crystal, and other delicate items must not touch each other during dishwasher operation. Damage may occur.
■Load lightweight plastic items in the top rack only. Only plastic items marked “dishwasher safe” are recommended.
■Load plastic items so the force of the spray does not move them during the cycle.
■To avoid chipping, do not let stemware touch other items.
■Small bowls, pans, and other utensils can be placed in the top rack. Load bowls in the center section for best stability.
Cup shelves (on some models)
Fold down the extra shelf on the
NOTE: The features on your dishwasher may vary from those shown below.
Light item clips (on some models)
The light item clips hold lightweight plastic items such as cups, lids, or bowls in place during washing.
To move a clip
1.Pull the clip up and off the tine.
2.Reposition the clip on another tine.
Side clip (on some models)
The side clip holds lightweight plastic items such as cups, lids, or bowls in place during washing.
To move a clip
1.Pull the clip up and off horizontal rack wire.
2.Reposition the clip on another horizontal rack wire.
Utensil clip (on some models)
The utensil clip holds specialty cooking items (wooden spoons, spatulas, and similar items).
To move a clip
1.Pull the clip up and off horizontal rack wire.
2.Reposition the clip on another horizontal rack wire.
Adjustable 2-position top rack (on some models)
You can raise or lower the top rack to fit tall items in either the top or bottom rack. Raise the top rack to accommodate items up to 9" (22 cm) in the top rack and 13" (33 cm) in the bottom rack, or lower the top rack to accommodate items up to 11" (28 cm) in both the top and bottom racks. Two adjusters are located on each side of the top rack. Each adjuster has 2 preset positions. The high and low positions are marked on the adjuster.
To adjust the top rack
1.Hold the top rack with one hand near the adjuster.
2.With the other hand, pull out the top of the adjuster.
3.Raise or lower the rack to one of the preset positions.
4.Release the adjuster.
5.Repeat the steps for the remaining adjusters.
NOTE: The top rack must be level.
8
