PROBLEM
Dishes not washing clean
Cloudy film on glassware, etching - permanent corrosion
Dlshes & lnterlor of dlshwasher yellow or brown
CAUSED BY
Water is not hot enough
Improper loodrng
Spray arm or arms not rotating freely
Not enough detergent or improper
detergent “0ld”detergeni
Water pressure may
be low, dishwasher IS not filling properly
Too much detergent rn soft water
Inadequate rinsing
Iron or manganese In water
SOLUTION
Water temperature should be at least 140°F (60°C). Set water heater thermostat to a higher setting. Run water at
srnk until hot before starting and/or use
Make sure dishes and glassware are loaded so spray reaches all surfaces and Items drain properly. Do not ov- erload Do not nest Items
Make sure large items do not block spray from reaching detergent dispensers
Check spray arms to make sure they turn freely after load- ing. Be sure a utensil has not prevented theirturning
Use more dishwasher detergent Use detergent with high-
est available phosphorus content. especially with hard water
Use only fresh dishwasher detergent. Store tightly closed container, in cool, dry place. Discard old detergent. Do not fill dispensers until ready to start dishwasher.
If water pressure IS low, do not use water for other purposes while dishwasher IS running (to assure correct fills).
Check for rainbow hue on glosses. A rainbow hue is the first sign of etching (corrosron of glass). Reduce the amount
of dtshwosher detergent Use a detergent with a lower phosphorus content.
If water pressure IS low do not use water for other purposes while drshwasher IS running (to assure correct water fills). Make sure dishes and glassware are loaded properly to
assure adequate rinsing and draining. Do not overload.
Temporary remedy:
I. Set empty dishwasher for a “one wash” cycle
2.Start drshwosher and unlatch door to stop it when it has frlled for the wash port of the cycle.
3.Add ‘~4to 12 cup (120 to 240 ml) of citric acid crystals
(usually available in drugstores]
Rust spots on stalnless steel
Dark spots on flatware - stalnless steel, rllver plate, or sterllng
Bronze tarnish on silverplate
Water left in bottom of dishwasher
Allowrng salty or acidrc foods such OS
mayonnarse, vinegar, frurt juices. salad dressings, milk products to remarn on flatware
Undrssolved
detergent coming in contact with flatware
Silverplate is worn off Exposed base metal to kes on a bronzed hue
Drshwosher cycle not completed
Clogged dram air cm
4 Close | and | latch | door | to | complete | cycle. |
|
| ||||
Permanent | solution: | Instoll | an | iron | or manganese | filter to | ||||||
home | water | supply |
|
|
|
|
|
|
|
| ||
Rinse | flatware | that | is | to | stand | for | several | hours | before | |||
washing |
| (use Rinse & Hold) Clean stained items with silver | ||||||||||
polish and | Do | not | put | stalnless | steel and | sliver | ||||||
flatware |
| In | the | same | sllverware |
| basket | compartment. | ||||
Direct | contact | between |
| these | metals can cause perma- | |||||||
nent damage | to | the | sliver. |
|
|
|
|
|
| |||
Remove spots with silver polish. Avoid spilling concentrated | ||||||||||||
detergent | on | wet | flatware. |
|
|
|
|
|
|
Remove tornrsh with silver polish Have silver replated
Allow drshwosher to complete cycle
Some plumbing codes require use of a drain air gap be-
tween an undercounter dishwasher and the drain system of the house. The air gap is usually located above the sink or on the top of the counter near the dishwasher to prevent the possibility of water backing up from the drain into the
dishwasher due to a plugged drain. The drain air gap is
NOT a part of the dishwasher and is NOT covered by the
dishwasher warranty The drain air gap should be kept clean to insure proper draining of the dishwasher