Whirlpool DU78OOXS manual Energy saving tips, To add a dish after starting

To add a dish after starting

I. To be sure the added item is washed and rinsed, make sure the Cycle Control Knob has not passed LOW ENERGY WASH.

2.Unlatch the doorto stop the cycle.

3.Open the door and add the dish,

4.Close the door. Do not latch it. Wait 30 sec- onds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restati- ing the cycle.

5.Latch the door. The dishwasher will start from where it stopped.

Energy saving tips

You can help save energy if you:

1.Wash full loads. Running a half-filled disn- washer uses the same amount of electricity and hot water as a fully loaded machine.

3.Air dry dishes when you don’t need a rapid drying cycle. Allow longer drying times [overnight].

2.Use the LOW ENERGY WASH Cycle whenever possible. It uses less hot water and energy than otherwash cycles.

4.load correctly for best washing results. In- correct loadrng may cause poor washing and the need to rewash all or part of the load.

5.Don’t pre-rinse normally soiled dishes. Se- lect the correct cycle for the load and use

the recommended amount of detergent for good washing results without hand rinsing.

6.Use your dishwasher during off-peak hours.

Local utilities recommend this to avoid heavy usage of energy at CertCIin timEi of day.

7.Kitchen cleanup can be done quickly and efficiently through the use of your dishwasher.

Most appliance parts that can fit in the dish- washer can be cleaned by it. Burned-on soil, however, should be cleaned by hand.