HEAT DRY
AIR DRY
The AIR DRY signal light will be ON when AIR DRY is selected. The AIR DRY Option helps save en- ergy, but the dishes take
longer to dry (overnight] and some water spot- ting may result. Some items (such as plastics) may need towel drying. For best results, use a liquid rinse aid such as
When
ing, the WATER HEATING signal light will be ON. POTS & PANS has the
NOTE: The WATER HEATING signal light will flash at the end of the cycle if the water did not heat to 14s”F (63°C). (See page 17.)
DELAY Pad
| . | - |
| The | DELAY | Pad | |||
|
| allows |
| you |
| to | |||
.- |
| D 1 |
|
| |||||
| delay | the | start | of | |||||
Biil | .- |
|
| ||||||
|
| a | cycle | for | 2, | 4 | |||
|
|
|
|
|
|
|
| ||
|
|
|
| or | 6 | hours | after | ||
loading the dishwasher. For example, use DELAY to run the dishwasher during
1.Press the DELAY pad once to display the last cycle and options selection.
2.Quickly press the pad again to select a 2 hour delay. The 2 HOURS signal lightwill come on.
3.Pressing the DELAY Pad repeatedly will select (in order] 4 hours, 6 hours, no delay, then 2 hours, etc. If no delay is selected, all delay signal lights will be off.
CANCEL Pad
IThe CANCEL pad allows you to cancel a cycle, to
clear the signal lights or to make a new selection.
IIf the dishwasher is wash-
ing, it will go into a 2 minute drain automatically
4.After 2 hours, the selected signal light will turn off. If 4 hours or 6 hours was chosen, the signal light for the next shorter delay time will turn on and continue to count down. This continues until the delay time ends and the dishwasher starts.
l You may press START at any time during the
delay if you want the dishwasher to start immediately.
l Press the CANCEL pad to cancel the delay and clear the delay signal light.
l You may add items to the load at any time during the delay. Close the door firmly to latch it.
before shutting off. Pressing CANCEL again stops the drain. If the dishwasher had not been started or is not washing, it will clear the display. Press- ing CANCEL again will start a 2 minute drain, if needed.
Adding a dish after starting
1.Lift up on the door latch to stop the cycle. Don’t open the door until the spray arms stop spinning.
2.Open the door and add the dish.
3.Close the door. Do not latch it. Wait 30 sec- onds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.
4.Press door firmly to latch it. The dishwasher
will automatically start where it stopped.
10
