CONTROL PADS
Five control pads and the signal lights al- low you to set and check the dishwasher’s function. A “beep”sounds each time a pad is pressed under normal conditions.
When first installed, the signal lights will flash rapidly in order. The signal lights will also flash following a power failure. Press the CANCEL pad twice to clear the signal lights. To start the dishwasher, press the STARTpad once to display the cycle. The dishwasher is preset for the NORMAL cycle with the HEATDRY option. If you want this cycle, press STARTagain.
To select a different cycle and/or option, just press the CYCLE pad and/or OPTIONS pad until the cycle and/or option you want is indicated by the signal lights. Each press of the pad advances the signal light to the next cycle or option. Press STARTto begin the cycle you selected. After each use, the
dishwasher remembers the cycle and options used. The next time the display is lit up for selection, it will show the last cycle that was run.
When dishes are loaded and ready to be
washed...
1.Read “Important Safety Instructions” on page 2 before starting your dishwasher.
2.Spin the Upper and Lower Spray Arms to make sure nothing will stop them from turning freely.
3.Push door firmly when closing and it will automatically latch.
4.Run hot water at sink nearest dishwasher until it is hot. Turn it off.
5.Pressthe STARTpad. Skip to step 7 if you want to run the cycle indicated by the signal lights.
6.You may select a different cycle by pressing the CYCLEpad. You may select a different option by pressing the OPTION pad.
7.Press the STARTpad again.
NOTE: Cycle and option selections are
cancelled by a power failure.
Selecting a cycle
POTS & PANS
Maximum cleaning for
WASHING | AND | RINSING | AND |
HEATING | WATER | HEATING | WATER DRYING CLEAN |
**Cycle time includes heated dry times.
8
