Changing or cancelling a program
After a program has started, touch CANCEL
Pad once. The dishwasherwill automatically go into a 2 minute drain period, then shut off. Check detergent dispensers to make sure they are filled properly for the new program. To restart the dishwasher, touch SELECTPROGRAM and SE- LECT OPTlON Pads, then touch START.
To cancel a program:
l Touch CANCEL Pad once. The dishwasher Will
automatically drain for 2 minutes, then shut off.
OR
l Touch CANCEL Pad twice. The display will clear and the dishwasher will immediately shut off.
Electronic display and status indicators
The electronic | display shows... | l “E4or | E2” | shows | whenever | there has been a | |
|
| control | panel malfunction. |
|
| ||
|
| Touch CANCEL Pad to clear display. The dish- | |||||
|
| washer may drain before shutting off. If the | |||||
|
| display | will | not | clear, call | your | |
|
| service | technician. | (See page | 15.) | ||
l The number of minutes remaining in a pro- gram (60, 59, 58 minutes, etc.). This displayed time only represents the wash, rinse and HEAT DRY time. The program time delays while the water is heating.
l The number of delay hours selected (I, 2, .... 9). The display also points out operating problems:
l “PF”shows on the display whenever there has
heen n newer intnrrlmtinn nr fnillrrn
Status Indicators let you know what your dish- washer is doing during a program.
WASH shows on the display during the wash portion of the program. The indicator goes off when the last wash is completed.
RINSE shows on the display during the two final rinses before drying.
CLEAN shows on the display immediately after the last rinse when AIR DRY is selected, or at the end of HEAT DRY Touch CANCEL Pad to clearthe display.
HEAT WATER shows on the display wheneverthe water is being heated in the POTS & PANS Pro- gram or when the HI TEMP Option has been selected.
To add a dish after starting
1.To be sure the added item is washed, make
sure the WASH Indicator is still on. The display flashes when the door is left ajar.
2.To stop the program, unlatch the door by pushing in the latch handle under the con- trol panel. Do not open the door until the spray arms stop spinning. The display will flash.
3. Open the door and add the dish.
/j’
4.Close the door, Do not latch it. Wait 30 sec- ondsforairinthedishwashertowarmup.This
helps reduce the amount of moisture that can come from the vent when restarting the program.
5.Push in on door until it latches. The dish-
washer will restart and continue the program.
