Whirlpool DU9500XR manual Dishes not washing clean

Dishes not washing clean

Cloudy tiim on glassware, etching - permanent corrosion

Dishes & interior of dishwasher yellow or brown

Rust spots on stainless steel -OR-

Dark spots on flatware - stainless steel, silver plate, or sterling

Bronze tarnish on silverplate

Water iett in bottom ot dishwasher

Water is not hot enough

Improper loading

Spray arm or arms not rotating freely

Not enough detergent or improper

detergent

“0ld”detergent.

Water pressure may

be low, dishwasher is not filling properly

Too much detergent in soft water

Inadequate rinsing

mm-!-

Iron or manganese in water

Allowing salty or acidic foods such as

mayonnaise, vinegar. fruit juices, salad dressings, milk products to remain on flatware.

Undissolved

detergent coming in contact with flatware

Silverplate IS worn off. Exposed base metal to kes on a bronzed hue.

Dishwasher cycle not completed

Clogged drain air gap

Water temperature should be at least 140°F (60°C). Set water heater thermostat to a higher setting. Run water at

sink until hot before starting and/or use HI-TEMP WASH Option.

Make sure dishes and glassware ore loaded so spray reaches all surfaces and items drain properly. Do not ov- erload. Do not nest items.

Make sure large items do not block spray from reaching detergent dispensers.

Check spray arms to make sure they turn freely after locd- ing. Be sure a utensil has not prevented their turning.

Use more dishwasher detergent. Use detergent with high-

est available phosphorus contenttespeciclly with hard water.

Use only fresh dishwasher detergent. Store tightly closed container, in cool, dry place. Discard old detergent. Do not fill dispensers until ready to start dishwasher.

If water pressure is low, do not use water for other purposes while dishwasher is running [to assure correct fills).

s1-91.-d.- Y”.-I-I_ ,. ,_e. ,~. ,

Check for rainbow hue on glosses. A rainbow hue is the first sign of etching (corrosion of gloss]. Reduce the amount

of dishwasher detergent. Use a detergent with 0 lower phosphorus content.

If water	pressure is low		do not use water for other purposes
while	dishwasher	is running			(to	assure	correct	water	fills].
Make	sure dishes	and		glassware		ore	loaded	properly	to
assure	adequate	rinsing		and	draining.		Do not	overload.
				-pe~-U..,-I-.,..				...^ i

Temporary remedy:

1.Set empty dishwasher for a “one wash” cycle.

2.Start dishwasher and unlatch door to stop it when it has filled for the wash port of the cycle.

3.Add % to % cup (120 to 240 ml] of citric acid crystals

(usuclly available in drugstores).

4.Close and latch door to complete cycle.

Permanent solution: Install on iron or manganese filter to home water SUDDIV.

Rinse	flatware		that		is	to	stand	for	several	hours	before
washing		[use Rinse & Hold]. Clean stained items with silver
polish and re-wash.					Do	not put		stainless		steel and	silver
tiatware		in	the	same		silverware			basket	compartment.
Direct	contact		between				these metals can cause perma-
nent damage			to	the	silver.
Remove spots with silver polish. Avoid spilling concentrated
detergent		on	wet	flatware.
					c-		-	---v_Iv		.~y”_L.-.III_Y-I .
Remove tarnish with silver polish. Hove silver replated.
			-ez-muI-eI_					,.~-----	^	._

Allow dishwasher to complete cycle.

Some plumbing codes require use of a drain air gap be-

tween on undercounter dishwasher and the drain system of the house. The air gap is usually located above the sink or on the top of the counter near the dishwasher to prevent the possibility of water backing up from the drain into the

dishwasher due to a plugged drain. The drain air gap is

NOT a port of the dishwasher and is NOT covered by the

dishwasher warranty. The drain air gap should be kept clean to insure proper draining of the dishwasher.

14