Starting your dishwasher ,k, Selecting a cycle

Starting your dishwasher ,k

The controls are behind a tilt-out panel. Just tilt it forward from the top to reach the controls. When it is tilted out, the display - above the controls - will show 2 zeros.

The dishwasher is pre-programmed for the NORMAL WASH Cycle and AIR DRY Option. If your want this cycle, just touch START.To select a different cycle and option, justtouch the de- sired pad. The Signal Light on the pad will come on to show the cycle about to be run.

When dishes are ready to be washed...

1.Spin the Upper Spray Arm to make sure nothing will stop it from turning freely.

Selecting a cycle

POTS 6 PANS Cycle

Maximum cleaning for cooked- or baked-on foods. Timer delays while

the dishwasher automatically heats the water to 145-F (63 C) in both washesand the last rinse [marked ‘1, Cycle time will be about 1% to 2

hours, depending on time needed to heat water.

HEAVY WASH Cvcle

A double wash for heavily soiled loads. Cycle time is about 60 minutes.

TILT-OUT

PANEL

2. Close and latch the door.

3. Run hot water at the sink nearest -1 the dishwasher until it is hot.

4.Open the tilt-out panel.

5.Touch a Cycle Selector for the desired cy- cle [if other than NORMAL WASH).

6.Touch an Option Selector for desired option or options.

7.Touch START.

WASH LIGHT	RlNSE,LlGHT	DRY LIGHT CLEAN LIGHT
.	---

WASH LIGHT	RINSE LlGHl	DRY LIGHT CLEAN LIGHT
	h-e-

NORMAL WASH Cycle

WASH LIGHT

RINSE LIGHT

DRY LIGHT CLEAN LIGHT

For normal, everyday soiled loads. (The Energy Guide Label data is based on this cycle.) Cycle time is about 55 minutes.

LOW ENERGY WASH Cycle

WASH LIGHT RINSELIGHT DRY LIGHT CLEAN LIGHT

For pre-rinsed or lightly soiled loads. Cycle time is about 50 minutes.

CHINA CRYSTAL Cycle

A light wash and gentle dry for china and crystal. Unless AIR DRY is selected, the heating element

cycles on and off during the “dry” part of the cycle. Cycle time is about 35 minutes.

RINSE & HOLD Cycle