Attaching the ice maker to a water supply Read all directions carefully before you begin.
Electrical Shock Hazard
Disconnect electrical supply to refrigerator before
installing.
Electrical drill must be grounded before drilling
holes in water line.
Failure to do so could result in death, electrical
shock, or serious injury.
IMPORTANT:
l
Use copper tubing only and check for leaks.
l
Install ice maker tubing in areas where temperatures
are above freezing.
Tools required:
l
Standard screwdriver
l
‘he-inch and N-inch open-end wrenches or
two adjustable wrenches
l
X-inch nut driver
l
%-inch drill bit
l
Hand drill or electric drill (properly grounded)
NOTE:
Your appliance dealer has a kit available with a
X-inch saddle type shut-off valve, a union, and copper
tubing. Before purchasing, make sure a saddle type
valve complies with your local plumbing codes. Do not
use piercing type or %-inch saddle valve which
reduces water flow and clogs more easily.
IMPORTANT:
. It may take up to 24 hours for your ice maker to
begin producing ice.
l
If operating the refrigerator before installing the water
connection, turn ice maker to the OFF position to
prevent operation without water.
l
All installations must be in accordance with local
plumbing code requirements.
INSTALLATION IS NOT WARRANTED
BY REFRIGERATOR OR ICE MAKER
MANUFACTURER.
Cold water supply
Ice maker water valve contains a flow washer which is
used as a water pressure regulator. The ice maker
needs to be connected to a cold water line with water
pressure limitations of 20-l 20 psi. If a problem occurs,
call your utility company.
18