Whirlpool ED22PB Before Using Your Refrigerator, Cleaning it, Plugging it in, In This, Section

Before Using Your

Refrigerator

In This	Section	Page		Page
Cleaning	it	...... 5	Installing	it properly	6
Plugging	it in	...... 5	Leveling	it .,	6

It is important to prepare your refrigerator for use. This section tells you how to clean it, connect it to a power source, install it and level it.

Cleaning it

Removing packaging materials

Remove tape and any inside labels (except the model and serial number label) before using the refrigerator.

NOTE: Do not remove any permanent instruction labels inside your refrigerator. Do not remove the Tech Sheet fastened under the refrigerator at the front.

To remove any remaining glue:

l Rub briskly with thumb to make a ball, then remove.

OR

l Soak area with liquid hand-dishwashing detergent before removing glue as described above. Do not use sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners. These can damage the material. See “Important Safety Instructions” on page 3.

Cleaning it before use

After removing all packaging materials, clean your refrigerator before using it, if necessary. See cleaning instructions on pages 21-22.

Plugging it in

Recommended Grounding Method

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.

See Electriil Requirements and Ground- ing Instructions Sheet in your Literature Package.

a-prong grounding type wall receptacle

Refrigerator power cord

grounding

PM

5