Before using your refrigerator
1. Remove sales labels...
Remove the Consumer Buy Guide label, tape and any inside labels before using the refrigera- tor To remove any remaining glue:
1.Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with liquid hand dishwashing de- tergent before removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can dumage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the front.
2. Clean it...
Clean your refrigerator before using it. See cleaning instructions on page 8.
3. Plug it in...
TYPE WALL RECEPTACLE
REFRlGERAiOR | |
POWER CORD | GROUNDING PLUG |
4. Install properly...
II
1.Allow 3 inches (7.5 cm] between overhead cab- inets and refrigerator top.
2.Allow at least an inch (2.5 cm) between the re- frigerator condenser on the back and the wall.
3.Allow ‘/2inch (1.25 cm) on each side of the refrig- erator for ease of installation.
4.If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider.
5.Level refrigerator-freezer...
USE SCREWDRIVER
TO ADJUST
RAISE
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only | 15 or | 20 ampere | fused | |||
and properly | grounded | electrical | supply | is re- | ||
quired. | It is recommended | that | a | separate | circuit | |
serving | only | this appliance | be | provided. |
| |
Do not use an extension | cord. | Use a recepta- |
cle which cannot be turned off with a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package.
RIGHT TO RAISE;
LEFT TO LOWER
1.To raise front, turn each screw to the right
2.To lower front, turn each screw to the left.
3.Check with level.