Install properly.. .
+
1.Allow 3 inches (7.5 cm) between overhead cab- inets and refrigerator top.
2.Allow at least an inch (2.5 cm) between the re- frigerator condenser on the back and the wall
3.Allow Y2 inch (1.25 cm) on each side of the re- frigerator for ease of installation.
4.If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and any inside labels before using the re- frigerator To remove any remaining glue:
1.Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with liquid hand dishwashing detergent before removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTIONS LABELS INSIDE YOUR REFRIGER- ATOR.
Do not remove the Tech sheet fastened under the refrigerator at the front.
Clean it...
Clean your refriger- ator before using it.
See cleaning in tions on page 8.
Level | . | Plug it | in... |
USE SCREWDRIVER |
| ||
|
|
| |
TO ADJUST |
| GROUNDING | |
LEVELLING SCREW |
| TYPE WALL | RECEPTACLE |
R&E |
|
| |
I |
| I |
|
LEFT TO LOWER
1.To raise front, turn each screw to the right
2.To lower front, turn each screw to the left.
3.Check with level.
|
|
| . |
| |||
REFRIGERATOR | PLUG |
| |||||
POWER CORD | GROUNDING |
| |||||
|
|
|
|
| |||
RECOMMENDED | GROUNDING | METHOD |
| ||||
A 115 Volt, 60 | Hz., AC only | 15 or 20 | ampere fused | ||||
and | properly | grounded | electrical | supply | is | ||
required. | It is recommended |
| that a separate | cir- | |||
cuit | serving | only this appliance | be | provided. |
|
Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package.