Whirlpool ET1NK manual Install properly, Remove, sales, labels, Clean it, Plug it in

Install properly..	.	Remove		sales		labels .. .
		Remove the Consumer Buy Guide label, tape and
		any inside labels before using the refrigerator
		To remove any remaining glue:
		1 Rub briskly with thumb to make a ball then remove
		OR
		2 Soak area with dishwashing detergent solution (I
		teaspoon		detergent		in 1 quart warm			water]	before
		removing glue as descrrbed In step 1.
		DO NOT		USE rubbing			alcohol	or	flammable	or
		toxic	solvents,		such	as acetone,		gasoline, car-
		bon	tetrachloride,			etc.	These	can	damage	the
		material.
		NOTE: DO NOT REMOVE ANY PERMANENT IN-
		STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
		Do not remove the Tech Sheet fastened under
		the	refrigerator		at the		front.

1 Allow 3 ,nches (7 5 cm) between overhead cabl- nets and refrigerator top

2 Allow at least an Inch (2 5 cm) between the refrigerator condenser on the back and the wall

3 Allow : Inch (1 25 cm) on each srde of the refrigerator for ease of lnstallatron

4 If the refngerator ISto be against a wall, you might want to leave extra space on the hinge side so the door can be opened wrder

Clean it...

Clean your refrigerator before usrna It.

See cleaning rnstructions “: on page 8

Plug it in...

&prong grounding type wall receptacle,

Level refrigerator-freezer.. .

Levelling Leg

Raise Lower

This refrigerator has 2 threaded levelling legs that are shipped in a separate package

I. Screw these legs all the way into bolt holes in the bottom front corners of refrigerator

2.Roll the refrigerator into place.

3.Lower legs just enough to M-tfront rollers off floor

4.Adjust front legs to level the refrigerator

-To raise corners, turn legs in direction shown.

-To lower corners, turn legs In directron shown.

5.Check with level.

III 3-prong

111~, grounding plug

t

Refrigerator

Power Cord

RECOMMENDEDGROUNDING METHOD

A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused

and properly grounded electrlcal supply IS re-

quired It IS recommended that a separate clrcurt serving only this appliance be provided

Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See tndtvrdual electrlcal requtre- ments and grounding Instructron sheet In your Ilter- ature package