Whirlpool ET20AK tnstall properly, Remove sales labels, Level refrigerator-freezer, Plug it in

tnstall properly...	Remove sales labels...
	Remove the Consumer Buy Guide label, tape
	and any	inside	labels	before	using the re-
	frigerator. To remove any remaining glue:
	1. Rub briskly with thumb to make a ball then
	remove.
	OR
	2. Soak	area	with liquid	hand	dishwashing
	detergent before removing glue as described
	In step	1.

DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-

bon tetrachloride, etc. These can damage the material.

NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTIONS LABELS INSIDE YOUR REFRIGER- ATOR.

Do not remove the Tech sheet fastened under the refrigerator at the front.

I. Allow Yzinch (1.25 cm] space on each side and

at the top of the refrigerator for ease of installation.

2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider.

3.The refrigerator back can be flush against the wall.

Clean		it...
Clean		your	refrtger-
ator	before using			it.
See	cleaning		instruc-		\l i~il:	jj,l;I
tions	on	page	8.	n

Level refrigerator-freezer.. .

FRONT ROLLER I I

VELLING SCREW

LEFl TO LOWER

1.Remove base grille (see page 7).

2.To raise front, turn screw in the direction shown.

3.To lower front, turn screw in the direction shown.

4.Check with level.

5.Replace base grille (see page 7).

Plug it in...

3-PRONG GROUNDING TYPEWALL RECEPTACLE

REFRIGERATOR			B-PRONG
			GROUNDING			PLUG
POWER CORD
RECOMMENDED			GROUNDING		METHOD
A 115 Volt,		60	Hz., AC only	15 or 20		ampere fused
and	properly		grounded	electrical		supply	is
required. It is recommended					that a separate		cir-
cuit	serving	only this appliance			be	provided.

Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package