Whirlpool ET20EK Reversing the door swing, Changing the light bulb Optional automatic ice maker

Reversing the door swing. .,.

You can change the hinges on your refrigerator so the doors open the other way, Refer to the instruction sheet included with your refrigerator.

Changing the light bulb...

Optional automatic ice maker.. .

lower Slgnal Arm to Start It.

I r&e

:on

Al 7

Ra- ise Signal

Arm to Stc-. ,p Ice Maker.

If you have the automatic ice maker accessory or plan to add one later (Part No. ECKMF-61). there are a few things you will want to know:

l The ON/OFF lever is a wire srgnal arm. Down...fcr making ice automattcally. Up...toshut off the ice maker.

l Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacrty.

WARNING: Before removing a light shield for cleaning or for replacing the bulb, unplug the refrigerator or turn off the

electrlclty leadlng to the refrlg- erator at the maln power supply. Shock and Injury could occur.

Light bulb behind light shield:

1.Push lightly on top center of the light shield until the notched tab unhooks from the control panel

2.Pull down on the shield until the tab clears the con- trol panel.

3.Lift the back hooks out of the slots.

4.Replace with a 40.watt appliance bulb

5.Replace light shield in reverse order

l It is normal for ice crescents to be attached by a corner. They will break apart easily.

l You will hear water runnina when ice maker is working. You’ll hear ice fall%to the bin. Don’t let these sounds bother you.

l The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight.

l Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice.

l If Ice is not being made fast enough and more ice is needed, turn the Temperature Control toward a higher number. Wait a day and, If necessary. turn the Air Control toward A.

l If you remove the Ice brn, raise the signal arm to shut off the ice maker. When you return the bin, push it all the way in and lower the arm to the ON posrtion.

l If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes In the ice brn can also become smaller by evaporation.

l The ice maker water supply should not be soft- ened water. The chemicals could damage the ice

maker molds.

Removing the base grille.. .

l Pull grille outwards as shown

l Do not remove Tech sheet fastened behind grille

Support Tabs

To replace:

l Line up grille support tabs wtth metal clips

lPush firmly to snap into place. l Close the door.