Install properly.. .
I, Allow % inch (1.25 cm) space on each side and at the top of the refrigerator for ease of installation.
2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wrder
3.The refrigerator back can be flush agarnst the wall.
Level refrigerator-freezer.. .
Levelling | SK4 | 1 |
Right to Raise;
Left to Lower
I. Remove base grille [see page 7):
2.To raise front, turn each screw to the rrght.
3To lower front, turn each screw to the left.
4Check with level
Remove sales labels.. .
Remove the Consumer Buy Gurde label, tape and any lnslde labels before using the refrigerator
To remove any remaining glue:
1.Rub briskly with thumb to make a ball then remove
OR
2.Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water) before removing glue as described in step 1.
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under the refrigerator at the front.
Clean it.. .
Clean your refrigerator before using tt.See cleaning instructions on page 8 and 9
Plug it in...
grounding plug
t
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch
or pull chain. See individual electrical requrre- ments and grounding instruction sheet in your Irter- ature package.
A
