Whirlpool ET22ZM manual Changing the light bulb, Automatic ice maket, Removing the base grille

Changing the light bulb...

WARNING: Before removing the light shield for cleaning or for replacing the bulb, either unplug refrigerator or discon-

nect electricity leading to re- frigerator at the main power supply. Shock and injury can occur if elec- tricity remains connected.

Push in the Center;

Pull Down.

Push lightly on the top center of the light shield until the notched iab unhooks from the control panel Pull down on the shield until the tab clears the con- trol panel

LIH the back hooks oui of their slots Replace with a 40-watt appliance bulb Replace light shteld in reverse order

Automatic ice maket..

The automatic Ice maker ISin the freezer section of your refrigerator. The following things should be known for proper Ice maker use

lThe ON OFF lever ISa wire signal arrr

Down for making ice automat~cal’i Up to shut off the ice maker

l Shake the bin occasionally to keep &oes sey;c rated, and to obtain Increased storage capac~+r

On

Lower		Signal		\	Raise	Signal
Arm	to	Start	It	Arm to Stop Ice Maker
l It	IS normal		for Ice c’escents	tc be	attached	Lr -J

corner They will break apart easllv

l You will hear water ruqnlng w?en ice maker i working You’ll hear Ice fall into: ti‘e tl ‘I ?\I~I t -.I

l

l

l

l

l

l

these sounds bother you

The ice maker will not operate until the freezer IS cold enough to make ice This can take overnight Because of new plumbing connectIons, the first Ice may be &colored or off-flavored Discard the first few batches of Ice

If Ice ISnot being made fasi enough and more ice ISneeded, turn the Temperature Control toward a higher number. Wait a day and, If necessary, turn the Air Control toward A

If you remove the Ice bin, raise the signal arm to snu+ off the ice maker When you return the bin. push It all the way in and lower ihe arm to the ON position

If cubes are stored too long, they may develop an off-flavor like stale water Throw them away They WIII oe replaced Cubes In the Ice bin can also become smaller by evaporation

Good water quality ISimportant for good Ice quality I+IS not recommended that the Ice maker be con- nected to a softened water supply. Water softener chemicals such as salt from a malfunct~onlng soft- ener can damage the Ice maker mold and lead to poor quality ice If a softened water supply cannot be avoided, then It ISimportant that the water soft- ener be well maIntaIned and operating properly

Removing the base grille...

Support labs

To replace:

? Liqe up grille support tabs with metal clips

L Pull grille outwards as shown? Push,firmly to snap tnto place 3 Do not remove Tech sheet fas’ened behlno gril c? 3 Close the doors