Install properly.. .

3II I I m

i

1 Allow 3 inches (7.5 cm] between overhead cab-
inets and the refrrgerator top.
2. Allow at least an inch (2.5cm) between the refrrg-
erator condenser and the wall
3. Allow % inch (1.25 cm) on each srde of the re-
frigerator for ease of installation.
4. If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be
opened wider.

Level refrigerator-freezer...

Remove sales labels.. .

Remove the Consumer Buy Guide label. tape and
any inside labels before using the refrrgerator.
To remove any remaining glue:
1 Rub briskly with thumb to make a bail then remove.
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent In 1 quart warm water] before
removing glue as descrrbed In step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.

Clean it.. .

Clean your refrigerator before using it See clean-
ing instructrons on pages 7 and 8.

Plug it in...

3-prong
grounding type
wall receptacle
Raise
This refrigerator has 2 threaded levelling legs that are
shipped in a separate package.
1. Screw these legs all the way into bolt holes in the
bottom front corners of refrigerator
2. Roll the refrigerator into place.
3. Lower legs just enough to lift front rollers off floor.
4 Adjust front legs to level the refrigerator
~ To raise corners, turn legs counterclockwise.
- To lower corners, turn legs clockwise.
5. Check with level.
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrical supply
IS
re-
quired It
IS
recommended that a separate circurt
serving only this appliance be provided
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See individual electrrcal requlre-
ments and grounding Instructron sheet in your Irter-
ature package.