Whirlpool ETIGJK manual Adjusting the shelves, Removing crispers and crisper cover, Ice cube trays

Adjusting the shelves.. .

1First, remove food from shelf.

2.Slide shelf straight out to stop.

3.Lift front.

4.Slide the rest of the way out. Replaclng Shelf:

I, Fit back of shelf on top of guides with wire stops on the bottom of guides.

2. Lift front, slide shelf In until it clears guide stops. Shelf Guide

Removing crispers and crisper cover.. .

Removing the Crispers:

1 Slide crisper straight out to stop, lift front, then slide the rest of the way out.

2. Replace In the reverse order.

Removing Cover:

I. L1f3front and remove the cover support 2. Lift out cover by pulling up and out Replacing Cover:

1.Fit back of cover into notch supports on walls of refrrgerator, then lower front into place.

2.Replace cover support with the long tab towards the front. Note: If support needs adjustment, turn base right to lower, or left to raise

Ice cube trays...

To remove ice:

tHold tray at both ends.

2 Slrghtly twrst

Lift the Front, Then the Back.

Pull out to stop. the Front and Pull Again.

If cubes are not used, they may shrink. The moving cold air starts a slow evaporation The longer cubes are stored, the smaller they get

Optional automatic ice maker.. .

On

. daise Signal

LArm to Stop Ice Maker

Lower Signal Arm to Start It

If you have the automatic ice maker accessory or plan to add one later (Part No ECKMF-83). there are a few things you will want to know:

l The ON/OFF lever is a wire signal arm. Down.. .for making ice automatrcally; Up...toshut off the ice maker.

l Shake the brn occasionally to keep cubes sepa- rated, and to obtain increased storage capacity.

l

l

l

l

l

l

l

l

It is normal for Ice crescents to be attached by a corner. They will break apart easily.

You WIII hear water running when ice maker is working. You’ll hear ice fall into the bin Don’t let these sounds bother you.

The ice maker WIII not operate until the freezer is cold enough to make ice. This can take overnight. Because of new plumbing connections. the first ice may be discolored or off-flavored. Discard the first few batches of ice.

If ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and, If necessary, turn the Freezer Control toward A.

If You remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin. push it all the way In and lower the arm to the ON position.

If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes in the ice bin can also become smaller by evaporation,

The ice maker water supply should not be sott- ened water. The chemicals could damage the Ice maker molds.

6