Install | properly.. | . | Remove | sales | labels.. . |
|
| ||||
|
|
| Remove the Consumer Buy Guide label, tape and | ||||||||
|
|
| any inside labels before using the refngerator. |
| |||||||
|
|
| To remove any remaining glue: |
|
|
| |||||
|
|
| 1 Rub briskly with thumb to make a ball then remove. | ||||||||
|
|
| OR |
|
|
|
|
|
|
|
|
|
|
| 2 Soak area with dishwashing detergent solution (1 | ||||||||
|
|
| teaspoon | detergent | in 1 quart | warm | water] | before | |||
|
|
| removing glue as described in step 1 |
| |||||||
|
|
| DO NOT | USE rubbing | alcohol | or | flammable | or | |||
|
|
| toxic solvents, such as acetone, gasoline, car- | ||||||||
|
|
| bon | tetrachloride, |
| etc. | These | can | damage | the | |
|
|
| material. |
|
|
|
|
|
|
| |
|
|
| NOTE: DO NOT REMOVE ANY PERMANENT IN- | ||||||||
|
|
| STRUCTION LABELS INSIDE YOUR REFRIGERATOR. | ||||||||
|
|
| Do not remove the Tech Sheet fastened under | ||||||||
|
|
| the | refrigerator | at | the | front. |
|
|
|
\u
1.Allow 3 Inches (7 5 cm) between overhead cab- inets and the refrigerator top
2Allow at least an inch (2 5cm) between the refrlg- erator condenser and the wall.
3.You don’t need space between counters and cabinets and the refrigerator sides. For ease of
~nstallation,you might wanttoleaveenough room (‘1~ inch - 1.25 cm) so the refrigerator can be moved easily.
4.If the refrigerator ISto be against a wall. you might want to leave enough space so the door can be opened wider.
Clean | it.. . |
|
| |
Clean | your | refrigerator | @ . |
|
before | using | It. |
|
|
See cleanlnq | instructions |
|
| |
onpage7. | - | I | A | |
|
|
|
Plug it in...
Level refrigerator-freezer...
Levelli
Raiselower
I, Keep the 4 bolts that hold refrigerator and shipping crate. They are the levelling legs.
2.Screw these bolts all the way into bolt holes at the bottom corners of refrigerator.
3.Adjust each leg until the refrigerator won’t rock. Slide refrigerator into place.
4.Adjust front legs to level the refrigerator.
5.Check with level.
0x4
ng Plug
Retrigbotor
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
4