Whirlpool ETl2EC Changing the light bulb, Ice cube trays, Sounds you may hear, Energy saving tips

Models: ETl2EC

1 12
Download 12 pages 52.59 Kb
Page 6
Image 6
Changing the light bulb. ..

Changing the light bulb. ..

WARNING: Before removing the light bulb, either unplug the refrlgerator or disconnect

the electricity leading to the re- frigerator at the main power supply. Shock and injury can occur if elec- tricity remains connected.

I. Reach behind control console to find bulb

2.Remove bulb

3.Rep/me with opphance bulb only

Ice cube trays.. .

To remove Ice:

lHold tray at both ends l Slightly twist.

Sounds you may hear...

If cubes are not used, they may shrtnk The movrng cold air starts a slow evaporatron The longer cubes are stored. the smaller they get

l Water Sounds:

l Running Sounds:

Your new refrigerator may make sounds that your old one drdn’t Because the sounds are new to you, you might be concerned about them Don’t be Most of the new sounds are normal Hard surfaces like the floor, walls and cabinets can make the sounds seem louder.

The followtng chart describes the kinds of sounds that might be new to you, and what may be makrng them

When the refrigerator stops running. you may hear gurgltng in the tubing for a few minutes after It stops You may also hear defrost water running into the defrost water pan

Your refrigerator has a high-effrcrency compressor and motor It ~111run longer than older designs. It may even seem to run most of the time

Energy saving tips.. .

You can help your refrigerator use less electrrcrty.

l Check door gaskets for a tight seal. Level the cab- rnet to be sure of a good seal

l Clean the condenser coil regularly

l Open the door as few times as possrble. Thank about what you need before you open the door Get everything out at one time. Keep foods orga- nized so you won’t have to search for what you want. Close door as soon as food is removed.

l Go ahead and fill up the refrigerator, but don’t overcrowd it so air movement is blocked.

l

l

l

It is a waste of electrrcrty to set the refrigerator and freezer to temperatures colder than they need to be If ice cream IS firm in the freezer and drinks are as cold as your family likes them. that’s cold enough

Make sure your refrigerator is not next to a heat source such as a range, water heater. furnace. radiator, or in direct sunlight

Keep the Power Saving Control on OFF unless moisture forms on the refrigerator exterior.

6

Page 6
Image 6
Whirlpool ETl2EC manual Changing the light bulb, Ice cube trays, Sounds you may hear, Energy saving tips