Whirlpool ETl4JM Before using your refrigerator, Remove sales labels, Install properly, Clean it

Models: ETl4JM

1 16
Download 16 pages 13.8 Kb
Page 4
Image 4
Before using your refrigerator

Before using your refrigerator

1. Remove sales labels...

Remove the Consumer Buy Guide label, tape and any lnslde labels before using the refrigera- tor. To remove any remaining glue:

1.Rub briskly with thumb to make a ball then remove.

OR

2.Soak area with liquid hand dishwashing de- tergent before removing glue as described in step 1.

DO NOT USErubbing alcohol or tlammable or toxic solvents, such as acetone, gasoline, car- bon tetrachlorlde, etc. These can damage the materlal.

NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.

Do not remove the Tech sheet fastened under the refrigerator at the tront.

4. Install properly...

1II-l

2. Clean it...

Clean your refrigerator before using it. See cleaning instructions on page 8.

3. Plug- it in...

J-PRONG GROUNDING

TYPE WALL RECEPTACLE

1.Allow 3 inches (7.5 cm] between overhead cab- inets and the refrigerator top.

2.Allow at least an inch (2.5 cm) betweenthe re- frigerator condenser on the back and the wall.

3.Allow YZinch (1.25 cm] on each side of the re- frigerator for ease of installation.

4.If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider.

Level refrigerator-freezer.. .

REFRIGERATOR

3-PRONG

POWER CORD

GROUNDING PLUG

RECOMMENDED GROUNDING METHOD

A 115Volt, 60 Hz.,AC only 15 or 20 ampere fused and properly grounded electrical supply is re- quired. It is recommended that a separate circuit serving only this appliance be provided.

Do not use an extension cord. Use a recepta- cle which cannot be turned ofl with a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package.

LEVELLING LEG

This refrigerator has 2 threaded levelling legs that are shipped in a separate package.

1.Screw these legs all the way into bolt holes at the bottom corners of refrigerator. Roll refrigera- tor into place.

2.Lower legs just enough to lift rollers off floor.

3.Adjust each leg until the refrigerator won’t rock.

4.Adjust front legs to level the refrigerator.

-To raise corners, turn legs in direction shown.

-To lower corners, turn legs in direction shown.

5.Check with level.

4

Page 4
Image 4
Whirlpool ETl4JM manual Before using your refrigerator, Remove sales labels, Install properly, Clean it, Plug- it in, 1II-l