Whirlpool ETl8CK Install properly, Level refrigerator-freezer, Remove sales labels, Clean it

Install properly.. .

1 Allow 3 Inches (7 5 cm) between overhead cab- lnets and the refrigerator top

2Allow at least an tnch (2 5 cm] between the refrig- erator condenser and the wall.

3Allow 1%inch (1.25 cm) on each srde of the re- frigerator for ease of Installation.

4If the refrigerator ISto be against a wall, you might want to leave enough space so the door can be opened wider

Level refrigerator-freezer...

Use Screwdriver	Leveling	screw
to Adjust

Left to Lower

1 To raise front, turn each screw to the right 2 To lower front, turn each screw to the left 3 Check with level

Remove sales labels.. .

Remove the Consumer Buy Guide label and other InsIde labels before using the refrigerator Any glue left can be taken off with rubbing alcohol.

NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR. Do not remove the Tech Sheet fastened under

the refrigerator at the front.

Clean it...

Clean your refrigerator before usrng It See clean- ing Instructions on page 8.

Plug it in...

3-prong grounding type wall receptacle

Refrigerotol

Power Cord

RECOMMENDEDGROUNDING METHOD

A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused

and properly grounded electrical supply is re-

quired. It IS recommended that a separate circuit serving only thts appliance be provided.

Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your Irter- ature package

4