I 1I’
Install properly.. .
111;)i0
1 I
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and any inslde labels before using the refrigerator.
To remove any remaining glue:
1 Rub briskly with thumb to make a ball then remove
OR
2 Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water) before removing glue as described in step 1.
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetmchloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under the refrlgemtor at the front.
Clean it...
1.Allow 3 inches (7.5 cm) between overhead cab- Inets and the refrigerator top
2.Allow at least an Inch (2.5cm) between the refrlg- erator condenser and the wall
3.Allow % inch (1.25 cm] on each side of the rem frigerator for ease of lnstallatlon
4If the refrigerator ISto be agolnst a wall, you might want to leave enough space so the door can be opened wider
Level refrigerator-freezer...
Levelli
This refrigerator has 2 threaded levelling legs that are shipped in a separate package.
1.Screw these legs all the way into bolt holes in the bottom front corners of the refrigerator.
2.Slide the refrigerator into place.
3.Adjust front legs to level the refrigerator.
4.Check with level.
Clean your refrigerator before using It See clean- Ing instructions on page 7
Plug it in...
t
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
4