Install | properly.. | . | Level | . | |
|
|
| Use Screwdriver | Leveling screw |
|
|
|
| to Adjust |
|
|
Right to Raise;
Left to Lower
1 To raise front, turn each screw to the right 2 To lower front, turn each screw to the left 3 Check with level
1 Allow 3 Inches (7.5 cm] between overhead cabi- nets and refrigerator top
2 Allow at least an inch (2.5 cm] between the refrigerator condenser on the back and the wall.
3. Allow K inch (1.25 cm] on each side of the refrigerator for ease of Installation.
4 If the refrigerator ISto be against a wall, you might want to leave extra space on the hinge side so the door can be oDened wider.
Clean it.. .
Clean | your | refrigerator |
|
before | using | it |
|
See cleaning | instructions | A | |
on page | 8, | i | |
|
| ||
Plug it in...
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and any inside labels before using the refrigerator.
To remove any remaining glue:
1 Rub briskly with thumb to make a ball then remove
OR
2.Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water) before removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Refrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrical supply IS re-
quired. It IS recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instructlon sheet in your liter- ature package
