Adjusting the refrigerator shelves...
To remove the shelves:
1.First,remove food from shelf.
2.Slide shelf straight out to the stop.
3.Lift front, slide shelf the rest of the way out.
To replace | the shelves: |
|
1. Fit back of shelf on top of guides with wire stops |
| |
on the | bottom of guides. | GUIDE |
2. Lift front, slide shelf in until it clears guide stops.
Removing crispers and crisper cover...
To remove the crispers:
1.Slide crisper straight out to the stop.
2.Lift the front.
3.Slide the rest of the way out.
4.Replace in reverse order.
To remove the cover:
1.Lift front and remove the cover support.
2.Lift out cover by pulling up and out.
To replace the cover:
1.Fit back of cover into notch supports on walls of refrigerator, then lower front into place.
2.Replace cover support with the long tab toward the front. NOTE: if the support needs adjust- ment, turn base right to raise, or left to lower.
Changing the light bulb...
| 1. Reach behind the control console to find bulb. | ||
ry& | 2. | Remove | bulb. |
| 3. | Replace | with a |
Reversing the door swing...
You can change the hinges on your refrigerator so the doors open the other way. You will need a #20 Torx head screwdriver. Refer to the instruction sheet included with your refrigerator.
Ice cube trays...
(Model ETWK)
If cubes are not used, they may shrink. The mov- ing cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.
-I
To remove ice:
1.Hold tray at both ends.
2.Twist slightly.
6
