Removing the bottom trivet, The signal light

Removing the bottom trivet...

To remove:

1 Lift front of trivet out of supports

2 Pull out

To replace:

1 Positton back of trivet on the rear wall supports 2 Lower front in+0 L3lace

Lift the Front,

Then Pull Out.

Energy saving tips...

You can help your freezer use less electricIVy

l Check door gasket and level freezer to assure a good door seal

l Clean the car ,derlser coils regcllarly

l Keep door openings to a minimum Remove several items at one time Keep contents organized to elimi- nate searching

l FIII to capaci+v Follow recommended procedures for freezlng foods See pages 8 and 9

car help reduce the hazard of child ertrapmept

To lock or unlock the freezer you must hold the key in the lock while turning The lock IS spring loaded so the key cannot be left in the lock

If the key 1s lost, contact your WHIRLPOOL

dealer for a replacement Always give the com- plete model and serial number of your freezer

when requesting a replacement key.

l Set Temperature Control to provide temperatures around 0°F ( 17.8 “C) There is no need to store foods below 0°F

l Keep door locked to ensure door closure

l Do not let frost build up to more than inch (6 mm] thick Efficiency ISreduced

l Keep Power Saving Control on OFF when humlclty IS

IObV

automatically warns of any unexpected power failure.

Signal Light

l l l

			To replace	burned	out	signal	light:
			I. Unplug power cord from outlet
If the signal light	is not glowing, immediately	check.	2. Open the freezer door
			3. Unplug	burned out	light	and	replace with one of
for power interruption,
			same wattage and size Signal light can be
for an unplugged	power cord,

	for a burned out signal light	ordered from your WHIRLPOOL dealer,
	for a burned out signal light	Part No. 530584
		Part No. 530584
		4 Close freezer door and plug power cord tnto outlet.