Install | properly... | Remove | sales labels... |
|
|
| |||
|
|
|
|
| |||||
|
| Remove the Consumer Buy Guide label and any | |||||||
|
| inside labels before using the freezer. |
| ||||||
|
| To remove | any | remaining | glue: |
|
|
| |
|
| 1. Rub briskly with thumb to make a ball, then | |||||||
|
| remove |
|
|
|
|
|
| |
|
| OR |
|
|
|
|
|
|
|
|
| 2 Soak area with dishwashing detergent solution (1 | |||||||
|
| teaspoon detergent in 1 quart warm water) be- | |||||||
|
| fore removing glue as described in step 1 |
| ||||||
|
| DO | NOT | USE rubbing | alcohol | or | flammable | or | |
|
| toxic | solvents, | such as | acetone, |
| gasoline, | car- | |
|
| bon tetrachioride, | etc. | These | can | damage | the | ||
|
| surface | finish. |
|
|
|
|
| |
|
| NOTE: DO NOT REMOVE the Tech Sheet fas- | |||||||
|
| tened | under the freezer | at the | front. |
| |||
t
1 Check the strength of the floor. It should hold the weight of a fully loaded freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow 3 Inches (7 5 cm) air space on top of freezer for proper ventilation
4 Allow at least an Inch (2 5 cm] between the freezer condenser, on the back of the unit, and the wall
5 Allow % Inch (1.25 cm] on each side of the freezer for ease of installation
6.If the freezer is to be in a corner, you might want to leave extra space on the hinge side so the door can be opened wider.
Level freezer.. .
SO the door will stay open at any position
I I
This freezer has 2 threaded leveling legs that are shipped in a separate package.
1.Screw these legs all the way into bolt holes in the bottom front corners of the freezer
2.Slide the freezer into place.
3.Adjust front legs to level the freezer
-To lower corners, turn legs in direction shown.
4.Check with level.
5.After freezer is fully loaded, recheck with level.
Clean it...
Clean your freezer befor using it See cleaning instructions on page 7
Plug it in...
Retainiyg Clip
Freezer / | 1:: | \ |
|
Power Plug | IN | &prong |
|
| grounding | plug | |
|
|
Recommended Grounding Method
A 115 Volt, 60 Hz,, AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only
this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.
Attach retaining clip over power cord plug from literature package inside the freezer.
