Whirlpool EV200D warranty Before you plug it in, Install Properly, Remove Sales labels, Clean It

Models: EV200D

1 8
Download 8 pages 38.94 Kb
Page 2
Image 2
Before you plug it in

Before you plug it in

Before using your freezer, you are personally responsible for making sure that il.

l is installed and leveled on a floor that will hold the weight, and in an area suitable for its size and use.

l is connected only to the right kind of outlet,

with the right electrical supply and grounding.

l is used only for lobs expected of home freezers

l is not near an oven, radiator or other heat source

Install Properly.. .

l is properly maintained.

l is in a dry sheltered place.

l is used in an area where the room tempera- ture will not exceed 110 F (43.3 C)

l is not run where there are explosive fumes.

l is not used by children or others who may not understand how it should be used.

l is not loaded with food before it has time to get properly cold.

Remove Sales labels...

Remove the Consumer Buy Guide label and any inside labels before using the freezer. Re- move any left over glue with rubbing alcohol.

INote: DC NOT REMOVE the Tech Sheet fas- tened behind the base grille.

I

_.

flush against back wall ond cabinets

Clean It...

Clean your freezer before ustng it See clean- ing instructions on page 5.

1.Check the strength of the floor. It should hold the weight of fully loaded freezer

2.Pick a safe place, indoors, away from in-

flammables such as gasoline.

3.Freezer may be installed flush against wall In back and cabinets on each side.

level Freezer.. .

 

so that door will stay open at any position.

1.

Remove

base

grille

[see

page4

). Y

2.

Starting

with

door

hinge

 

side,

q7

 

turn left to raise corner.

 

 

 

3.

Turn

right to

lower corner.

 

 

4.

Check

with

level.

 

 

2

 

 

 

 

 

 

 

 

 

 

5,

After

freezer

is

loaded

with

 

 

food,

recheck

 

wrth

level.

 

 

Plug it in...

3-prong grounding type wall receptacle

Recommended Grounding Method

A 120 Volt, 60 Hz., AC only, 15 ampere fused electrical supply is required. It is recommended that a separate circuit serving only this appli-

ance be provided. The receptacle should not be controlled by a wall switch or pull chain.

Do not use an extension cord.

See individual electrical requirements and

grounding instruction sheet in your literature package.

2

Raise Lower

Page 2
Image 2
Whirlpool EV200D warranty Before you plug it in, Install Properly, Remove Sales labels, Clean It, level Freezer, Plug it in