Using your freezer
Setting the Cold Control...
To start, turn control to the middle of the dial This setting will maintain zero zone temperatures under normal operating conditions
Note: When freezer is first started the compressor will run constantly until the cabinet is cooled It may take up to 6 to 8 hours or longer, depending
on room temperature and the number of times the freezer door is opened.
Afterthe cabinet is cooled the compressor will turn on and off as needed to keep freezer at proper temperature.
Adjusting Cold Control ...
o Turn control to higher number for colder temperatures
l Turn to lower number for less cold temperatures
Cooling Freezer First.. .
l Allow freezer to cool 6 to 8 hours before filling with frozen food.
l Let tt cool overnight before adding large amount of unfrozen food.
I II | POWER SAVING CONTROL | I II |
The Power Saving Control...
operates electric heaters. These heaters help prevent moisture from forming on the outside of the freezer when humidity is high.
lUse the OFF setting when humidity is low to save electricity.
l Use ON only if moisture forms on outside of freezer.
Exterior Signal light .. .
automatically | warns of any unexpected | power | To replace | burned | out | signal | light: |
failure |
|
| 1. Unplug | power | cord | from | outlet |
|
|
|
2. Remove base grille. See page4.
If the signal light is not glowing, immediately check,
l for power interruption,
l the power cord, it may be disconnected from the outlet,
l the signal light; it may be burned out
3.Unplug burned out light and replace with one of same wattage and size. Signal light can be ordered from your WHIRLPOOL dealer, Part No. 530584.
4.Replace base grille. See page 4.
5.Plug power cord into outlet.
3
