Whirlpool FES340V Electronic oven controls, Using the electronic Minute Timer, Setting the clock

The electronic oven controls

There are three parts in the oven control section:

-The digital display.

-The command buttons.

-The Time/Temp Set Knob and Set/ Cancel button.

Instructions for each oven control are covered on the following pages. Read them carefully.

When you first plug in the range, the display will show four flashing “8”sIf. after you set the clock (below) the display again shows four flashing “8’s, your electricity was off for a while. Reset the clock.

Digital display/clock

When you are not using the oven, this is an accurate digital clock. When using the oven or Minute Timer, the display will show the time, temperature settings and what command buttons have been pressed.

When showing the time of day, the display will show the hour and minutes.

When using the Minute Timer, the display shows minutes and seconds in the following sequence:

Command buttons

The command buttons tell the oven what to do and in what order. A few examples :

-Clock tells the oven you are going to set the clock.

-Set/Cancel tells the oven to turn off.

Each command button (except Set/ Cancel) has its own indicator. The indicator comes on when you touch the command buttons.

Time/Temp Set Knob

Once you’ve pushed a command button to tell the oven what you want it to do, you’ll use the Time/Temp Set Knob to set a temperature or time. Turning the Time/Temp Set Knob clockwise increases the number on the display. Turning the Time/Temp Set Knob counterclockwise decreases the number on the display.

Using the electronic Minute Timer

The Minute Timer does not start or stop the oven. It works like a kitchen timer. It can be set in minutes and seconds up to 9 hours 50 minutes. You will hear three beeps when the set time is up.

1.Push the Timer button. The TIMER indicator will come on and the large display will show “0:OO”.

2.Turn the Time/Temp Set Knob until the desired time shows in the large display. The Minute Timer will begin counting down 2 seconds after the time is set.

When time is up, you will hear three beeps.

To cancel the Minute Timer:

n Push the Timer button and hold it down for 3 seconds until time-of- day appears in the large display or turn the Time/Temp Set Knob until “0:OO”shows in the large display.

Using the Set/Cancel button

mFor settings from 0 minutes to 1 minute 55 seconds, the display will increase in 5-second increments.

1 For settings from 2 minutes to 9 minutes 50 seconds, the display will increase in lo-second increments.

. For settings from lo-59 minutes, the display will increase in 1 minute increments.

. For settings from 1 hour to 1 hour 55 minutes, the display will increase in 5-second increments.

. For settings from 2 hours to 9 hours 50 mmutes, the display will increase in lo-second increments.

When using Cook Time, the display shows hours and minutes.

Setting the clock

1.Push the Clock button. The TIME indicator will show in the display. Release the Clock button.

2.Turn the Time/Temp Set Knob until the correct time shows in the large display.

3.Push the Set/Cancel button to complete time-of-day entry.

The Set/Cancel button will cancel any command except for times set with the Minute Timer button. The large display will then show the time-of-day or, if Minute Timer is also being used, the time remaining.

Page 5