::LI i /i Li ! i ¸¸ :Ui IU! ?
Whenthe leftdoor isclosed,the hingedsection automaticallyforms
WATER CONNECTION
Disconnect the appliance from the mainspower supply
before starting operations.
•The icemaker andwater circuit must be connectedto a
water supplyofpotable and/or chemicallypurified water.
• The water connectionmust be carriedout in cornpliancewith
localregulations.
• The appliance issuppliedwith a water tube andwith a
transition connectorfor connectingto the water tube and
supply. (some models)
• Remove the protective cap from the end of the gray water
tubing.
• Connect the water tube (I) to the transition connector (2).
Fingertightening and then Ito 2 additional turns should be
adequate (for some models connector is placed directly on
water tube).
• Connect the transition connector (2) to the householdwater
supply (3).
• (4) Remove Plastic cap from water valve inlet port.
• (5) Placeend of Plastictubing into water valve inlet port.
• (6) Slide brassnut over sleeve and screw nut into inlet port.
Tighten nut with wrench. Do not overtighten. Connect tubing
to frame with water tubing clamp (C).
• Make sure that the water tube is not twisted.
• The appliance is pre-set for operation at pressures between
2.4and 8.3 bar (35and 120 PSI).
• Open the water tap. Check for andeliminate any leaks.
• The appliancedoes not require anyadjustment or water drain.

c .....i iiililiHHilHiilliii!iHl

i!i!!!i_!i_iiiiii_iiiji!iil
218