WASHER CARE (cont.)

Cancellation of Clean Washer Cycle Operation:

If the Clean Washer cycle is canceled by the user after it has been initiated, it may take up to 30 minutes for the washer to purge any affresh® Cleaner, chlorine bleach, or other chemistry from the wash system and to adequately rinse any remaining chemistry. The washer door will remain locked until the cancellation process has been completed. This assures no cleaning chemistry will be carried over to the next wash cycle and reduces the potential for damage to subsequent loads of laundry or to the washer itself.

Clean Washer Cycle Cancellation Procedure:

1.Press the POWER button on the washer two times.

2.The washer will begin to drain and rinse away the remaining cleaning chemistry.

3.The cycle will complete the cancellation process in approximately 30 minutes or less.

4.The washer then can be used to either repeat the Clean Washer cycle or to wash laundry using one of the regular wash cycles selected by the user.

Cleaning the Dispensers

After a period of using your washer, you may find some residue buildup in the washer’s dispensers. To remove residue from the dispensers, remove the drawer and wipe the surfaces with a damp cloth and towel dry either before or after you run the Clean Washer cycle. Use an all-purpose surface cleaner, if needed.

IMPORTANT: Dispenser is not dishwasher safe.

Cleaning the Outside of the Washer

Use a soft, damp cloth or sponge to wipe up any spills. Occasionally wipe the outside of your washer to help keep it looking new. Use mild soap and water.

IMPORTANT: To avoid damaging the washer’s finish, do not use abrasive products.

Cleaning the Precision Dispense Ultra Cartridge It is recommended that you rinse out the Precision Dispense Ultra cartridge when changing detergent types or concentrations, or when the washer will not be used for an extended period.

1.Pull dispenser out until it stops.

2.Lift out the Precision Dispense Ultra cartridge.

3.Lift cover on cartridge and flush interior thoroughly with warm water.

4.Allow to air dry or wipe with a clean, soft towel. IMPORTANT: Cartridge is not dishwasher safe.

WASHER CARE (cont.)

Removing the Dispensers

To remove:

1.Pull dispenser drawer out until it stops.

2.Press down on the release tab and pull straight out to remove the dispenser.

3.Lift off cover panel by

pulling straight up.

To replace:

1. Slide cover panel back onto posts on dispenser.

2. Align edges of dispenser with guides in washer, then slide dispenser back into slot.

14

Page 14
Image 14
Whirlpool Front-Loading Automatic Washer Cancellation of Clean Washer Cycle Operation, Cleaning the Dispensers, To replace