Installation Clearances
IMPORTANT: If you are installing your garage refrigerator under a workbench, allow a minimum of 1¹⁄₈ in. (30 mm) between the top of the refrigerator and the bottom of the workbench.
1
2
3
1.Workbench
2.1¹⁄₈ in. (30 mm) minimum space
3.Refrigerator
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection:
Recommended grounding method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control to the off position as shown and then disconnect the refrigerator from the electrical source.
1. Off position
When you are finished, reconnect the refrigerator to the electrical source and reset the control to the desired setting. See “Using the Control.”
INSTALLATION INSTRUCTIONS
Unpack the Refrigerator
WARNING
Excessive Weight Hazard
Use two or more people to move and install refrigerator.
Failure to do so can result in back or other injury.
1.Remove the refrigerator shipping carton, flatten it, and place it next to the refrigerator on the floor.
2.Unpack accessories and hardware from the small box. Verify contents. See “Tools and Parts.”
3.Untape and open the refrigerator door to remove the shelves and the installation instructions. Follow the instructions for proper assembly.
4.Retape the refrigerator door to keep it closed until the handle installation is complete.
Install the Caster Plate
WARNING
Excessive Weight Hazard
Use two or more people to move and install refrigerator.
Failure to do so can result in back or other injury.
IMPORTANT:
■Always lay the refrigerator on its side during the caster plate installation. If you lay the refrigerator on its back, you can damage the refrigerator.
■Never place refrigerator on its top. It may damage the compressor.
■Allow the refrigerator to sit on its casters for 4 hours before plugging into an electrical outlet.
1.Using 2 or more people, lay the refrigerator on its side.
4
