4.Run home power supply cable through strain relief, into terminal box.
A 
B
C
D 
EF
A.Home power supply cable
B.UL listed or CSA approved strain relief
C.Black wires
D.UL listed wire connectors
E.White wires
F.Green (or bare) and
5.Use UL listed wire connectors and connect black wires (C) together.
6.Use UL listed wire connectors and connect white wires (E) together.
Install DuctCovers
NOTE: Remove the film from the vertical duct cover supports and the duct covers.
1.Attach the vertical duct cover supports using 8 - 4 x 8 mm screws.
A
B
A
A.Screws
B.Vertical duct cover support
2.Slide the upper duct covers into place, and insert 3 tabs on each side of the duct covers into the mating slots of the vertical duct cover supports. Slide the duct covers up until the springs “click” and the tabs are locked in place.
WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire in terminal box.
Failure to do so can result in death or electrical shock.
7.Connect green (or bare) ground wire from home power supply to
8.Tighten strain relief screw.
9.Install terminal box cover.
10.Check that all light bulbs are secure in their sockets.
11.Reconnect power.
A
B
A. Upper duct cover
B.Spring
3.Slide the lower duct covers over the upper duct covers.
4.Attach the lower duct covers together using a plastic bracket at each top and bottom corner of the lower duct covers
(4 places).
C 
A
B
C
A. Upper duct cover
B. Lower duct cover
C. Plastic brackets
9
