24.Install filters. | Use and Care Information |
Vented installations: |
Make sure tabs are toward outside and bottom. Insert aluminum filter into upper track , push in and pull down .
Snap aluminum filter onto front of charcoal filter. Make sure that tab on aluminum filter lines up with finger pull on charcoal filter.
WARNING — To reduce the risk of fire or electrical shock, do not use this fan with any
WARNING — TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer. Before servicing or cleaning unit, switch power off at service panel and lock switch power off at service panel and lock service panel to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device such as a tag to the service panel.
CAUTION: For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.
WARNING — TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
Always turn hood ON when cooking at high heat or when cooking flaming foods.
Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.
Use proper pan size. Always use cookware appropriate for the size of the surface element.
WARNING — TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:
SMOTHER FLAMES with a close- fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
NEVER PICK UP A FLAMING PAN
— You may be burned.
DO NOT USE WATER, including wet dishcloths or towels — a violent steam explosion will result. Use an extinguisher ONLY if:
You know you have a Class ABC extinguisher, and you already know how to operate it.
The fire is small and contained in the area where it is started.
The fire department is being called.
You can fight the fire with your back to an exit.
Operation
Blower “SPEED”
Infinite speed slide control adjusts blower speed and sound level for quiet operation.
ONSPEED
BLOWER
ON
LIGHT
Push filter assembly into upper track
. Flaps on filter will flex against top and sides of opening. Push assembly up until bottom of assembly clears lip on bottom cover. Push in and pull assembly down
,collapsing pull ring against aluminum filters.
Blower “ON”
Turns blower ON and OFF. When this control is turned ON, blower will operate at preset speed of slide control.
LIGHT
•First position (ON) - Turns both bulbs ON.
•Second position - Turns
•Third position (▼ ) - Turns both bulbs OFF.
DO NOT install bulbs rated higher than 75 Watts. Install a smaller bulb on the right for a night light.
7
