4.From the diagrams below, select the diagram for your installation.
Vented installations: Cut the vent system and electrical wiring access holes as required. Either wiring hole can be used.
| |
(15.9 cm) | |
| (19.1 cm) |
centerline |
|
(13.0 cm) (3.5 cm) (3.2 cm) (5.4 cm) dia. hole
3-1/4" x 10" (8.3 x 25.4 cm)
RECTANGULAR VERTICAL
vent system
centerline | ||
cabinet | ||
dia. hole | ||
front | ||
|
1/8" | 3/4" | |
(3.2 mm) | ||
(19 mm) | ||
|
(9.8 cm) | (15.9 cm) | (19.1 cm) |
3-1/4" x 10" (8.3 x 25.4 cm) HORIZONTAL vent system
Prepare and install the hood
WARNING
Excessive Weight Hazard
Use two or more people to move and install range hood.
Failure to do so can result in back or other injury.
For Steps 5 through 10, refer to Figure 3.
5.Set hood upside down on a protective covering such as cardboard or large towel.
screws
bottom cover
filters
wiring box cover
screws
blower wheel
6.Remove bottom cover screws and bottom cover.
7.Remove filters.
8.Remove wiring box cover and screws.
9.To make the hood lighter and easier to install, it is recommended that the blower assembly be removed.
To remove:
a)Disconnect blower wiring plug.
b)Loosen, but do not remove, knurled nuts on mounting rods. Slip rods out of blower mounting brackets.
Important: Do not grasp blower by blower wheels. Wheels may be damaged.
c)Lift blower out and set aside.
10.Remove light lens. Squeeze sides of lens toward center to free lens tabs and lift lens out.
11.Depending on your installation, remove either back or top wiring knockout.
Figure 3
light lens
knurled
nut mounting rod
blower
assembly
mounting bracket
protective cover
For vented installations, go to Step 12a.
For non-vented installations, go to Step 13.
12a.Depending on your installation, remove either back or top vent knockout.
vertical | black | |
screws | ||
vent | ||
| ||
| hinge pin | |
| vent | |
horizontal | knockouts | |
| ||
vent |
|
black screws | hinge pin |
12b.Attach the damper/vent connector to the hood. Use the two black sheet metal screws provided in the parts bag. Note: If wall cap is directly behind vent connector, the dampers in the connector and wall cap MUST NOT interfere with each other. Remove the vent connector damper if they interfere.
5