End of cycle signal
The dryer sounds a signal to let you know when the cycle is finished. The signal is not adjustable and cannot be turned off.
The signal is helpful when you are drying permanent press, synthetics, and other items that should be taken out as soon as the dryer stops.
Selecting the right cycle and setting
The following pages describe the cycles on your dryer. Refer to the chart on page 9 for help in selecting drying cycles.
Drying guidelines
l Always follow care label directions when they are available.
lUse the Air cycle, or line dry rubber, plastic, delicate, and
lThe last few minutes of all cycles are without heat to make the load easier to handle.
l To help reduce wrinkling, remove the load from the dryer as soon as tumbling stops. This is especially important for permanent press, knits, and synthetic fabrics.
l Overdrying can cause shrinkage, static cling, and damage to some fabrics.
. Refer to pages
-sorting clothes for drying
-choosing load sizes
-drying tips
-using dryer fabric softeners
-saving energy
- drying | . |
|
Cycle descriptions
Automatic Permanent Press/
Regular Cycle(s)
Dry most loads using the Energy Preferred Automatic Setting (*). Your Automatic cycle(s) shuts off when the se- lected dryness is reached. The Cycle Control Knob will not move until the load is almost dry. After the
l If the load is drier than you like, select a | LDR3622D | LER3622D LGR3622D | |
setting closer to LESS DRY the next time | |||
|
| ||
you dry a similar load. |
|
|
. If the load is not as dry as you like, com- plete drying using a Timed cycle. Select a setting closer to VERY DRY the next time you dry a similar load.
7
