Assemble Range Hood
1.Install transition on top of hood (if removed for shipping) with 2 - 3.5 x 9.5 mm sheet metal screws.
A
B
A. Vent transition
B. 3.5 x 9.5 mm screw (2)
2.Position the 4 vertical supports (A) with the notches at the bottom and attach to the range hood using 16 - 4.2 x 8 mm screws.
3.Attach the horizontal support (B) using 8 - 4.2 x 8 mm screws.
B
A A
C 
C
A. Vertical supports
B. Horizontal support
C. Notched end
4.Attach a second set of vertical supports (A) and set the vertical height (B). See “Installation Dimensions” in the “Location Requirements” section to help determine the desired dimension for vertical height “B.”
Secure with 16 - 4.2 x 8 mm T20® screws.
Install Range Hood
Non-Vented (recirculating) Installation
1.Attach the air deflector to the upper horizontal support using 2 mounting screws.
B 
A 
B
A.Deflector
B.Mounting screws
2.Measure the length of 6" (15.2 cm) duct needed to connect the transition to the deflector.
NOTE: Vent should fit up inside the deflector 1" (2.5 cm) minimum.
3.Install vent between the transition and the deflector.
NOTE: To make vent installation easier, temporarily remove the deflector from the chimney support bracket and replace after vent section is in place.
4.Seal all connections with vent clamps. Continue with “Range Hood Installation” in this section.
Range Hood Installation
1.Using 2 or more people, lift the range hood assembly and attach it by snapping the vertical supports to the spring clips in the upper horizontal support bracket that is mounted to the ceiling.
NOTE: The range hood assembly must be held in place while you are installing the screws in the next step.
2.Install 16 - 4.2 x 8 mm screws and tighten to secure.
A
A A
B
A. Vertical supports
B. Vertical height
A. Mounting screws
Connect Vent System
1.Install vent system.
2.Push duct over the exhaust outlet. Seal all connections with vent clamps.
3.Use caulk to seal all openings.
8
