Whirlpool LI31HC/W10526058F Install Duct Covers, C A C, A Bc, B A C D, D C A

Install Duct Covers

NOTE: Remove the film from the duct covers.

1.Assemble the upper duct covers together and install the duct covers around the support frame. The larger hole in the flanges of the upper duct cover must be outside the smaller hole in the mating flange of the other upper duct cover.

2.Secure the upper duct covers together with two 3.5 x 6.5 mm screws at the top and two 2.9 x 3 mm screws at the bottom. Install 1 screw on each side at the top and bottom of the assembled duct covers.

A B

C

A

C

A. 3.5 x 6.5 mm Screws (2)

B. Assembly holes (larger hole outside of smaller hole on both sides)

C. 2.9 x 3 mm screws (2)

NOTE: For non-vented (recirculating) installation, the slotted holes in the upper duct covers will be visible when assembled. For vented installations, the slotted holes will be hidden down inside the lower duct covers.

A

BC

A. Top toward ceiling

B. Slots installed up for non-vented installations

C. Slots installed down for vented installations

3.Slide the upper duct covers up the frame to the ceiling and secure to the upper horizontal support with 2 - 3.5 x 6.5 mm screws.

B

A

C

D

A. 3.5 x 6.5 mm screw	C. Upper duct covers
B. Slotted holes (2)	D. Ceiling

4.Place the long end of the plastic clips (2) into the bottom of the front lower duct cover.

A

B

A. Lower duct cover - (front)

B. Plastic clips (2) (long end for front placement)

5.Install the lower duct cover (front) to the range hood canopy. Spread the lower duct cover opening slightly and position it over the upper duct cover. Set the lower duct cover in place. Position so the flanges of the lower duct cover set into the flanges of the upper duct covers.

D

C

A

	B
A. Range hood canopy	C. Lower duct covers
B. Plastic clips	D. Upper duct covers

10