Programming tone
Each time you touch a pad you will hear a tone. If you don’t hear a tone, it is because the instruction is not correct, or because the tones have been removed.
EXAMPLE: If you touch a Number Pad before you touch a Command The instruction is not correct.
Pad, you will not hear a tone.
If you want to remove the
programming tone and end of cooking tone (beep
every 60 seconds while “End” is displayed):
l Open the door.
l Touch CANCEL twice, then touch START.
l The tone will not sound for any touch.
If you want to replace the
programming tone and end of cooking tone (beep every 60 seconds while “End” is displayed):
l Open the door.
l Touch CANCEL twice, then touch START.
. The tone will sound for any correct touch.
If you want to remove all tones, except the minute timer signal:
l Open the door.
l Touch CANCEL twice, touch 0, then touch START.
l All audible tones will be cancelled.
l To replace the tones, repeat the above steps.
NOTE: If electric power ever goes off, the programming tones will again sound each time you touch a pad.
Setting the clock
When the oven is first plugged in, a tone sounds and the display shows 888:88. If the electric power ever goes off, the display will again show all 8’s when the power comes back on.
You can cook or use the Minute Timer without setting the clock, but the display will be blank after cooking
DO THIS... | THIS HAPPENS... |
1. Touch CLOCK SET.
2.Touch Number Pads for the correct time of day.
3.Touch START.
The Display will show a “0”and the colon will start to flash. The first Number Pad must be touched within 5 seconds or the Display will go blank. Touch CLOCK SETagain and continue.
The Display will show what numbers you touched in the order you touched them. This example shows 3:25.
The colon will stop flashing. The Clock is set.
If you have touched in an incorrect time, such as12:65, “Err”will show on the Display. Touch CLOCK SETand start over.
NOTE: To resetthe clock, touch CLOCK SET.The current time will show on the Display and the colon will flash. Continue to set the clock as shown above.
6
